Domo DO231SR Manual De Instrucciones página 65

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 69
www.domo-elektro.be
DO231SR
side movements to get all sides of the surface fibres then blot with a towel. Finish by
brushing in one direction to will give the fabric a uniform appearance.
Caution : always determine the colour-fastness on any fabric-especially with reds or
blues- by taking a clean, moist, hand towel and gently rubbing a small area as far
down on the back or other out of the way place on the furniture as possible. If colour
comes off on the towel, you may need to have the piece dry cleaned.
WINDOW, GLASS SURFACES AND MIRRORS
Use the dual edge glass and tile squeegee. Work with the vapor jet on using the top to
bottom movements. Use the squeegee with the vapor off to clean the water from the
glass. To do this without leaving streaks, use lateral movements from the top to the
bottom of the surface.
FIBERGLASS OR STAINLESS STEEL SURFACES
Use the floor brush or detail brush. Slowly move the brush over the surface to be
cleaned. The vapor will emulsify the dirt and grease on the surface. Follow behind
with a terry cloth towel over the brush to remove excess moisture and residue.
TIP : an old idea for polishing stainless steel is to wipe it down with seltzer soda
water after it is cleaned.
SOAP SCUM
Soap scum dissolves almost immediately under a combination of heat and moisture.
Rinse the surface with a small amount of water afterwards or go back over it once
more with a clean terry cloth towel.
NOTE : soap scum sometimes will develop a hard surface from waterborne minerals.
If this is the case, use the floor brush with no towel first to break up this surface – or
spray or wipe first with lemon, vinegar or seltzer soda water to soften the minerals.
Moving too slowly can dry out the soap scum and cause it to granulate on the surface.
The surface will have a gritty feel. If this happens, apply vapor to the surface with the
open brush again and re-clean.
GARDEN FURNITURE
Use any of the brushes depending on the surface area. Work quickly when cleaning
resin outdoor furniture. Finish by wiping with a towel.
BLINDS
Use the detail brush to clean blinds. Move the brush over the surface, allowing
enough time for the vapor to penetrate. Work quickly on PVC blinds. Test for colour
fastness on fabric blinds before using. Finish by wiping with a towel.
BATHROOM AREAS
To clean the bathtub or shower area, use the detail brush for grout, shower door
tracks, hard to get areas and heavily soiled areas. The dual edge window/tile squeegee
65

Publicidad

Tabla de contenido
loading

Tabla de contenido