After Using The Cleaner; Switching Off The Cleaner; Disconnecting Supply Lines; Rolling Up The Electrical Cord And Storing Accessories - Nilfisk Alto NEPTUNE 4 FA Instrucciones De Manejo

6 After using the cleaner

6.1 Switching off the
cleaner
6.2 Disconnecting supply
lines
6.3 Rolling up the electrical
cord and storing
accessories
6.4 Storing the cleaner
(below 0°C)
A A
1) Options / model variants
1. Close water tap.
2. Squeeze the spray gun han-
dle until the cleaner is de-
pressurised.
3. Lock the safety catch on the
spray gun.
Store the cleaner in a dry room
without danger of frost or protect
as below:
1. Remove the water inlet hose
from the cleaner.
2. Remove the spray lance.
3. Switch on the cleaner with
the main switch in position
"Cold Water".
4. Operate the spray gun.
5. Gradually pour antifreeze
(approx. 5 litres) into the wa-
ter tank (A).
6. During suction operate the
spray gun two or three times.
7. The machine is protected
1. Turn the main switch to posi-
tion „OFF".
2. Close water tap.
3. Squeeze the spray gun han-
dle until the cleaner is de-
pressurised.
4. Lock the safety catch on the
spray gun.
4. Switch off the cleaner.
5. Remove the water hose from
the cleaner.
6. Pull out the plug from the
electrical socket.
Risk of tripping!
To prevent accidents, always
carefully roll up the electrical
cord.
1. Wind up the cord
2. Wind up the high pressure
hose.
3. Place the spray lance into
the spray lance storage.
against frost when antifreeze
solution emerges from the
spray gun.
8. Lock the safety catch on the
spray gun.
9. Switch off the cleaner.
10. To avoid any risks, store
the cleaner temporarily in a
heated room before using it
again.
11. When the machine is put into
service again, the antifreeze
solution can be collected and
stored for future use.
NEPTUNE 4 FA
13