Non-Scheduled Maintenance; Splatter Shield Removal And Replacement; Replacing Oven Light Bulb - Amana MC52200 Serie Manual Del Propietário

Non-Scheduled Maintenance

An authorized servicer must inspect equipment annually.
Record all inspections and repairs for future reference.

Splatter Shield Removal and Replacement

When removing and replacing splatter shield, be
careful not to bend antenna.
1. Unplug oven before removing splatter shield to stop
antenna from rotating. Allow 30 seconds for fan to
stop.
2. Remove shield by placing thumbs in front of shield
(see diagram above). Press lightly toward back and
carefully lower front of shield away from antenna.
Pull shield forward, out of back slots, and out of
oven.
3. Replace splatter shield by fitting tabs into slots at
top of oven back. Lift and press front of shield
until shield snaps into place.
Important
Do not wash splatter shield in dishwasher.

Replacing Oven Light Bulb

To avoid electrical shock hazard unplug power cord
or open circuit breaker to microwave oven before
replacing light bulb.
To avoid burns and cuts, wear gloves to protect
hands should bulb break. If hot, allow bulb to cool.
Tools Needed
• protective gloves
• flat blade screwdriver
• 40-watt, 250-volt appliance bulb (available at grocery
or hardware stores)
1. Remove screw from access cover on top left
wall of oven exterior. Remove access cover.
2. Remove bulb.
3. Replace bulb.
4. Replace access cover and screw by reversing
procedure in step 1.
12
Caution
Caution