Velleman CAMCOLD23 Manual Del Usuario página 5

3. Use the mounting plate [1] to determine the position of the
mounting holes. Drill the holes.
4. Guide the power and video cable [9] through one of the cable
slots [8] and fix the mounting plate [1] on the ceiling or wall
with four screws.
5. Insert the lens enclosure [4] in the positioning ring [3] and slide
the fixation ring [2] over both. Point the camera towards the
desired field of observation and screw the fixation ring [2] back
on the mounting plate [1].
6. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) when connecting
multiple domes.
7. Connect the power connector [B] to a 12VDC power supply (not
incl.)
7. OSD Settings
There is a small joystick in the camera cable that allows you to
adjust the settings of the camera using an on-screen display (OSD).
In the OSD menu:
• NEXT/BACK: select this option and press the middle button to go
to the next/previous page of options in the menu.
• RETURN: select this option and press the middle button to return
to the previous level in the menu.
• EXIT: select this option and press the middle button to leave the
OSD menu without saving the settings.
• SAVE ALL: select this option and press the middle button to save
all settings.
• CAMERA RESET: select this option and press the middle button
to reset the camera to the factory defaults.
The OSD menu settings are described in detail below.
V. 01 – 08/05/2012
CAMCOLD23
• Press the middle button to access the menu, or
to select an option.
• Press the up and down buttons to move up and
down in the menu.
• Press the left and right buttons to modify the
menu parameters.
5 ©Velleman nv