Maintenance And Cleaning - FALMEC STELLA Manual De Instrucciones

Ocultar thumbs Ver también para STELLA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
H
METALLIC FILTERS AND CARBON FILTER
1. METAL FILTERS
To access the metallic filters open the AP panel (see fig. 1). To remove the grease-trapping
metallic filter pull on the handle.
2. CHARCOAL FILTERS
Hood not designed for charcoal filters.
I
LIGHTING
The range hood is equipped with high efficiency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CARBON FILTERS
Hood not set up for carbon filter.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid
that oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using
abrasive substances or rough cloths will inevitably damage the finish of steel. The steel
surface will be irrevocably damaged if the instructions above are not complied with.
Keep these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the
instructions above.
4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the motor assembly inside the range hood must not be
cleaned using liquids or solvents.
Do not use abrasive products. All the above operations must be performed after having dis-
connected the appliance from the mains power supply.
26
ASSEMBLY AND REPLACEMENT

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nuvola 140 ed gl fb exNuvola 90 ws gl fb ex

Tabla de contenido