Additional Accessories - Redmond RMC-M4502A Manual De Usuario

IV. ADDITIONAL ACCESSORIES
Additional accessories for multicooker REDMOND RMC-M4502A can be
purchased separately. Information on the assortment, pricing, and
compatible accessories is available through www.multicooker.com and
our authorized dealers.
V. CLEANING AND GENERAL MAINTENANCE
GUIDELINES
Before you start cleaning the device, make sure that it is unplugged and
has cooled down. Prior to the first use or in order to remove the odor,
steam half a lemon for 15 minutes using "BOIL/STEAM-FISH" program.
Use soft cloth and mild soap to clean. We recommend cleaning the ap-
pliance after each use.
Do not use a sponge with a hard or abrasive surface; solvent and abrasive
cleaning methods are not allowed.
Do not immerse the device in water or wash it under running water.
Clean the housing as needed, following cleaning and general maintenance
guidelines provided. We recommend cleaning the inner aluminum lid, the
removable bowl, and the steam valve after each use. The bowl is dish-
washer safe. Make sure to wipe the outer surface of the bowl after clean-
ing to ensure it is completely dry before next use.
To clean the inner lid:
1. Open the lid of the device.
2. Simultaneously press 2 plastic holders located on the inner side of the lid.
3. Gently remove the inner aluminum lid by pulling it towards yourself
and down.
4. Wipe the surfaces of both lids with wet cloth or tissue. Wash under
the running water, using mild soap if necessary. Not dishwasher safe.
5. Place the aluminum lid back into its slots, matching it with the main
lid, and push the holders until they click into place.
12
The steam valve is located on the upper lid of the device. To clean the
valve:
1. Carefully remove the cover of the steam valve by gently pulling it up
and towards yourself holding it by the ledge.
2. Firmly turn the holder located on the bottom side of the valve
counterclockwise (in direction of <open>) to remove.
3. Gently remove the rubber insert out of the holder. Clean all parts of
the steam valve following Cleaning Guidelines provided.
Caution! Do not twist or extend the rubber insert to avoid its deformation.
4. Carry out the assembly in return sequence: place the rubber insert
back into the holder, match the holder slots with the ledges on the
inner side of the valve and turn the holder clockwise (in direction of
<close>). Install the steam valve back into its slot located on the lid
of the device with the ledge facing the back.
The condensation accumulates in the special cavity around the bowl. Use
cloth or tissue to remove the condensation.