Application Examples - CST/BERGER MAGNA-TRAK 200 Serie Manual De Instrucciones

APPLICATION EXAMPLES

(1) The existing small covers on the tank can be located using the signal peaks. (Fig. 10)
(2) The center of a large manhole cover can be located in the middle between the signal
peaks. (Fig. 11)
(3) The course of a pipeline can be located lengthwise by following a low signal level. If there are variances
from the center of the piping, the signal peaks are displayed both on the left and on the right. The analogue
transverse bar on the display shows whether the variance is to the right or to the left of the piping. The
device must be pointed in the direction of the course of the pipe when following its course. (Fig. 12)
WARRANTY
Seven Year Warranty. CST/berger, warrants the MT200 series against defects in material and
workmanship for a period of seven years from the date of purchase. Defi cient products will be
repaired or replaced at CST/berger's discretion. For warranty and repair information, contact your
local distributor.
For U.S.A., Before returning the instrument to CST/berger, please call
(815) 432-9200 for a Return Authorization Number from our Customer
Service Department.
CST/berger's liability under this warranty is limited to repair or replacement of the unit. Any
attempt to repair the product by other than factory authorized personnel will void this warranty.
Calibration, batteries and maintenance are the responsibility of the user. Where permitted by law, CST/
berger is not responsible for incidental or consequential damages.
Agents of CST/berger cannot change this warranty. CST/berger is not responsible for damage
resulting from wear, abuse, or alteration of this product. The user is expected to follow ALL
operating instructions.
This warranty may provide you with additional rights that vary by state, province or nation.
IMPORTANT NOTE: The customer is responsible for the correct use and care of the
instrument. Moreover he is completely responsible for checking the job along its prosecution, and therefore
for the calibration of the instrument. Calibration and care are not covered by warranty.
Copyright © 2009 Robert Bosch Tool Corporation.
MT200 Series Locators • 11