Assembly - BABYTREND PY57 Manual De Instrucciones

ASSEMBLY

• To operate the brakes on the Wheels,
6)
press downward on the brake levers. To
release, lift upward on the lever (Fig. 6).
To use as a bassinet, skip to
ATTENTION:
step 11 for bassinet installation instructions.
FOLDING PLAYARD
• Release the hook and loop fastener
7)
holding the Mattress from underneath
the Playard floor or the Bassinet and set
the mattress aside.
• unlock top rails yet, center of
DO NOT
floor must be raised before top rails will
unlock.
• Rotate the center handle counter-
clockwise 90 degrees and raise the
center as high as the top rails (Fig. 7).
Gather the Legs and Wheels together
towards the center as close as possible
so that they nearly touch.
• Locate the rail latch release in the center
8)
and bottom side of each rail. Squeeze
the lever with two hands until the rail
releases the two tubes (Fig. 8a), then
push down (Fig. 8b).
NOTE: If the top rail(s) do not release
completely, DO NOT FORCE! Lift the
center of floor higher. Both tubes must
be released for the top rail to fold.
• Gather four corners and center all
9)
together tightly (Fig. 9). Wrap Mattress
around Playard frame with padded side
facing inward.
7
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 6
Rotate before
lifting
Fig. 7
2
Raise
Push
1
Tube Center latch
Latch release
TOP RAIL
Fig. 8a
• Secure the hooks and loop fasteners by feeding them through the loops on
10)
the end of the Mattress and folding them back onto themselves (Fig. 10).
• Place folded Playard into carry bag so that the handle comes through the
opening between each side of the zipper.
Fig. 8b
TO ASSEMBLE BASSINET
Playard must be fully assembled
ATTENTION:
and securely locked before installing or using
the bassinet feature. (See To Assemble Playard
section, step 1). You will need to remove the
mattress from the bottom of the Playard to use
inside your Bassinet.
• Connect opposing Mattress Support Tubes
11)
that are attached to the bottom of the
Bassinet (Fig. 11a).
• Before placing the Mattress into the Bassinet,
make sure Mattress Support tubes are
connected (Fig. 11b).
Connect
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 9 Fig. 10
Fig. 11a Fig. 11b
8