Publicidad
Idiomas disponibles
Idiomas disponibles
1. unplug the sander from the power source.
2. using the hex wrench provided, loosen the belt bed locking
screw by turning it counterclockwise.
3. Raise the sanding belt to a 45 degrees angle as show in FIG 4.
4. Pull the belt tension lever (10) out to release the belt tension.
5. Remove the old sanding belt (8) from driver and idler rollers.
See FIG 4.
6. Place a new sanding belt over the driver roller and idler roller
with the direction arrows running counter-clockwise. Be sure
the sanding belt is centered on both rollers.
7. Push the belt tension lever back into the locking position to
apply belt tension.
WARNING:
loaded. Be careful when pushing the tension lever
back into place to avoid personal injury.
INSTALLING TABLE ASSEmBLY (FIG 5,6,7)
To Install the Table Assembly for Use with Sanding Disc
1. unplug the sander from the power source.
2. Insert the position pin on the work table into the upper hole on
the machine. See FIG 5.
3. Insert the table lock knob (4) through a flat washer and the work
table slot and into the threaded hole of the base as shown on
FIG 5. Turn and tighten the table lock knob.
To Install the Table Assembly for Use with Sanding Belt
1. unplug the sander from the power source.
2. Remove the work support if it is on.
3. Place the belt bed in the vertical sanding position. Refer to
"Positioning the Belt Bed".
4. Insert the position pin on the table support into the position hole
on the belt bed as shown on FIG 6.
5. Insert the table lock knob through a flat washer and the table
support slot and into the threaded hole as shown on FIG 6. Turn
and tighten the table lock knob.
WARNING:
piece or your finger between the table and sanding
surface, the table edge must be no more than 1/16"
(1-2mm) from the sanding surface.
To adjust the gap between the table edge and sanding surface,
loosen the three hex head nuts at bottom of table and adjust the
table to make sure the table edge is no more than 1/16" (1-2mm)
from the sanding surface. See FIG 7.
INSTALLING WORK SUPPORT (FIG 8)
1. unplug the sander from the power source.
2. Place the work support (7) over the holes in the side of the tool
housing as shown in FIG 8.
3. using a hex wrench provided, fasten the work support in place
with the washers and hex head screws (7a).
mOUNTING BELT/DISC SANDER
If during operation of the belt/disc sander, there is any tendency
for the sander to slide or "walk" or to tip over, then the sander
must be secured to a work bench or other supporting surface using
fasteners (not supplied) through the mounting holes on the base.
The belt tension lever is spring
To avoid trapping the work
fIG 4
4
fIG 7
7a
8
10
fIG 5
4
fIG 6
7
fIG 8
9
Publicidad
