Grounding Instructions - Viking DrawerMicro VMOD5240 Guia De Instalacion

Unpacking your
DrawerMicro Oven
• Remove all packing materials from inside the Drawer-
Micro Oven. DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the top of the appliance.
Sealing Surface
Waveguide Cover
Oven Cavity
• Remove the feature sticker, if there is one. Check the
drawer for any damage, such as misaligned or bent
drawer, damaged drawer seals and sealing surfaces,
broken or loose drawer guides and dents inside the
cavity or on the front side of the drawer. If there is any
damage, do not operate the appliance and contact
your AUTHORIZED SERVICER.
Important Notes to the
Installer
• Read all of the Installation Manual before installing
the DrawerMicro Oven.
• Remove all packing material before connecting the
electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
Important Notes to the
Consumer
Keep this manual with your Use and Care Manual for
future reference.
• As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use and Care Manual. Read all
and follow carefully.
• Be sure your DrawerMicro Oven is installed and
grounded properly by a qualified installer or service
technician.
Clearances and
Dimensions
™
• Dimensions that are shown in figure 1 must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-
hand corner of the cutout. See figure 4.
• Contact surface must be solid and level. Pay special
attention to the floor on which the appliance will sit.
The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven (about 100 pounds).
• Check location where the DrawerMicro Oven will be
installed for proper electrical supply.
• Your appliance can be built into a cabinet or wall by
itself or under a gas or electric wall oven.
• Be sure that the clearance of the floor between the wall
oven and the DrawerMicro Oven is a minimum of 2".
• The microwave interior will easily accommodate a
9" x 13" oblong dish or a bag of microwave popcorn.
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The DrawerMicro Oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded in accordance with the National Electrical
Code and local codes and ordinances.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Do not use an exten-
sion cord. If the power supply cord is too short, have
a qualified electrician or serviceman install an outlet
near the appliance.
E3
PERMANENT AND CORRECT INSTALLATION
3-Prong
3-Prong Plug
Receptacle
Ground
Receptacle Box
Grounding Pin