Publicidad
15
30
31
15
Water Valve Mechanism - ADJUSTMENT PROCEDURE:
- Turn adjustment screw "Counter-Clockwise" until water flow from bubbler starts.
- Turn adjustment screw "Clockwise" until water flow stops, THEN turn an additional 1/2 turn.
NOTE: Adjustments stated above are viewed from underneath unit (bottom side of
dispenser panel).
NOTE: If continuous flow occurs at the end of the compressor cycle, turn cold control
counterclockwise 1/4 turn.
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSON
HANGER BRACKETS & TRAP
INSTALLATION
1) Remove hanger brackets fastened to backs of cooler by removing
one (1) screw.
2) Mount the hanger brackets and trap as shown in Figures 2 & 3.
NOTE: Hanger Brackets MUST be supported securely. Add fixture
support carrier if wall will not provide adequate support.
IMPORTANT:
•
4 1/8 in. (105mm) dimension from wall to centerline of trap must be
maintained for proper fit.
•
Anchor hanger securely to wall using all five (5) 5/16" dia.
mounting holes.
3) Install straight valve for 3/8" O.D. tube.
INSTALLATION OF COOLER
4) Hang the cooler on the hanger bracket. Be certain the hanger
bracket is engaged properly in the slots on the cooler back as
shown in Fig. 5.
5) Loosen the two (2) screws holding the lower front panel at the
bottom of cooler base and two (2) screws at the top. Remove the
front panel and set aside.
6) Connect water inlet line--See Note 4 of General Instructions.
7) Remove the slip nut and gasket from the trap and install them on
the cooler waste line making sure that the end of the waste line
fits into the trap. Assemble the slip nut and gasket to the trap and
tighten securely.
START UP
Also See General Instructions
8) Stream height is factory set at 45-50 PSI. If supply pressure varies
greatly from this, readjust stream height to approximately 1-1/2"
(38mm) above the bubbler guard by turning adjustment screw,
accessible by removing front push panel (See Fig. 4 & 5).
Replace the front panel and secure by retightening four (4) screws.
10) If a taste, odor or sediment problem is prevalent, try installing our
water filter module.
HAC8FSCGBLQ*1A, HAC8FSCGWFBLQ*1A
14
16
15
14
16
15
WWW.RESTROOMDIRECT.COM
PUSH BAR MECHANISM
MECANISMO DE BARRA DE EMPUJE
MÉCANISME DU BOUTON-POUSSOIR
17
2
A
14
C
14
9
13 B
FIG. 4
LEGEND
A) Note: Water flow direction
B) Adjust this screw to eliminate mechanism "Free Play" or continuous flow
from bubbler conditions. (See ADJUSTMENT PROCEDURE)
C) Stream height adjustment (see note #8)
CORRECT STREAM HEIGHT
ALTURA DEL CHORRO CORRECTO
CHAUTEUR DE FLUX CORRECT
Page 5
704 • 937• 2673
129 Oakpark Dr., Unit A, Mooresville, NC 28115
15
16
29
19
HANGER BRACKET
FIJADOR DE SUSPENSIÓN
SUPPORT DE SUSPENSION
COOLER BACK
SUPPORT DE SUSPENSION
ARRIÈRE DU REFROIDISSEUR
0000000560 (Rev. F - 01/19)
15
FIG. 5
FIG. 6
Publicidad
