sources will only switch on due to the time or
movement during the night.
Preparing the product
prior to initial use
Note: The product features a twilight sensor and
an On / Off switch
product on time is approx. 6 to 8 hours.
Unscrew the sphere
counter-clockwise. Set the On / Off switch
5
to the ON position before using it for the
6
first time.
Screw the sphere
into the solar module
uct in the sun.
Switching the product on / off
Slide the On / Off switch
The product will automatically switch on at
dusk. At dawn the product will automatically
switch off.
Slide the On / Off switch
tion. The product is permanently switched off.
42 GB/MT
. When fully charged the
6
from the solar module
4
clockwise all the way
4
and place the prod-
5
to the ON position.
6
to the OFF posi-
6
Replacing the
rechargeable battery
Note: The rechargeable battery
for prolonged operation. However, it may need to
be replaced after being used for a long time. Re-
chargeable batteries are subject to natural wear
and the output may decrease. For optimal perfor-
mance the batteries should be replaced every
12 months.
Replace the rechargeable battery as shown in
figures D–F.
Unscrew the sphere
Slide the On / Off switch
module
to the OFF position.
5
Remove the solar module
tube
or
.
2
3
Loosen the two screws
counter-clockwise using a suitable cross-tip
screwdriver and remove the housing
the remainder of the module (see Fig. D).
Then also loosen the three screws
underside of the cover counter-clockwise us-
ing a suitable cross-tip screwdriver and remove
the cover
from the remainder of the module
10
(see Fig. E).
Remove the rechargeable battery
place with a new, charged rechargeable bat-
tery of the same type (see „Technical data").
Please note the polarity (+ / -) when inserting
the rechargeable battery (see Fig. F).
is designed
11
counter-clockwise.
4
on the solar
6
from the spacer
5
on the underside
7
from
8
on the
9
and re-
11