Mobiclinic Libra Manual De Instrucciones página 13

Instruction Manual Libra
ES EN PT FR IT DE
3. When your hands rest comfortably on the handlebars, the thumb control levers should be within easy reach. The
right lever moves the scooter forward, the left one moves it backward. When you release both levers the scooter
will stop.
4. Steer the scooter by turning the whole steering column the way you want to go.
5. Practice driving where there are no obstacles. Start at the slowest speed and drive forward and backward; make
some turns. As you get more comfortable you can increase the speed by turning the speed dial toward the picture
of the rabbit.
6. If two Battery Gauge LED Lights be lit, you should plan to recharge the batteries very soon.
7. If the scooter stops, locate the circuit breaker on the top of the battery pack. Push it and try the scooter again.
8. When you are fi nished riding, turn off the key before getting off .
9. If you are fi nished riding for the day, immediately recharge the batteries.
OTHER OPERATING INFORMATION
-Release Throttle and allow scooter to stop completely before changing from forward to reverse or reverse to
forward.
-When turning a corner, swing the front wheels wide, because the back wheels will turn more tightly.
-Use the scooter only where it would be safe to walk.
-Use low speeds for reverse, downhills, ramps, curbs, or uneven surfaces.
OTHER OPERATING INFORMATION
Hill climbing: You may need to use a higher speed. Turn to lower speed before going downhill.
Down slopes: To proceed down steep slopes slowly, set speed control in proximity of the turtle. This enables driver
control, as the closer the speed control is set toward the turtle, the slower it will become. However, this scooter
will not self-accelerate down hills due to the automatic braking taking effect should you attempt to drive too fast.
If the scooter breaks down and must be moved, get off the scooter, push the Free-Wheeling Lever to N, move the
scooter slowly to a safe location, and move the lever back to D.
DISASSEMBLING YOUR SCOOTER
NO TOOLS ARE NECESSARY. YOU CAN DISASSEMBLE SCOOTER FOR TRANSPORT
Remove seat by releasing Seat Rotation Lever(A)and then lift off.
Gently lift rear storage cover (B).
(B)
(A)