PNI Escort P05 A Manual De Usuario página 4

EN
5. Before installation, check the camera's field of view after feeding it.
Installation and testing:
1. After installing the sensors, arrange them in the correct direction. Arrange the threads in order.
2. Plug the red lead from the control unit into the "+" light of the turn signal lamp, and the black lead at "-".
Connect the red camera cable back to the "+" of the muzzle lamp. The screen must be connected to the ACC
feed, the table must be connected to the straightening thread. (please study the connection diagram).
3. Connect the screen to the control unit. Connect the "Vout" output on the control unit to the "Video 2" input
on the screen.
4. Put the switch in the march to test if the screen is working. In this situation, on the screen in the mirror you
should have the image behind the car, you will have a white dot at the bottom of the image. This indicates that
the system is under test.
Test:
a. If the rear image does not appear on the screen, please check that the polarity of the power supply is the
correct one if the cables are connected correctly and if the voltage is greater than 10.5V. Check if the screen
connector is well connected.
b. If the distance displayed on the screen is not in line with reality or is displayed at 0.0, or a steady sound is
heard, please unplug the system, and try again to insert the gear lever into the march. If problems can not be
solved, the unit is damaged and needs to be changed.
c. When testing the sensors, if the screen will sound continuously or display 0.0, please check that some parts
of the machine or other objects are within the range of the sensors, if the sensor is incorrectly mounted in the
hole, or if the sensor is under the influence strong sources of interference (such as exhaust pipes, other wires).
d. If a number is displayed on the screen but there is no obstacle in front of the sensors, make sure that the
sensors are wrongly facing down, please check the position and direction of the sensors. The sensors must
be mounted horizontally. Sensors can detect (if incorrectly mounted) the registration number, the spare wheel
or the rear spoiler.
e. If problems can not be solved after tests, sensors may be considered defective or do not match the control
unit. The whole system should be replaced.
f. If the image is in gradient or overturned, please check the connection of the camera.
g. For abnormal display with stripes or tilted lines, please check the compatibility between the screen and the
camera.
h. The screen can be interchanged, but the sensors and the control unit are compatible one by one.
i. For safety reasons, the screen will only show 0.0, instead of 0.3-0.1, when it detects something within 0.0-0.4
m depending on the software. In this situation, the driver must stop immediately. When the distance is 0.5 m,
the alarm sound will sound and will last for 1 second. Please be careful during maneuvers.
Notes
• Be aware of the size of the sensor mounting hole
• During installation of the system, the engine of the car must be switched off
• System performance can be altered in the following cases: heavy rain, paved road, uneven road,
vegetation, extremely hot weather, wet or cold, snow, mud or ice on sensors
• System operation may be affected by the presence of other ultrasonic waves, such as a 24 / 12V converter
• The sensors should not be mounted too tightly or too lightly
• The metal bumper can affect the performance of the system
• Do not position the control unit near the exhaust pipe or other wires
• Test the system to make sure it works properly
• This system is designed to assist the driver in parking. The manufacturer does not take responsibility for
accidents after installation.
We recommend installing the system at an authorized service center.
The supplier does not assume responsibility for defects caused by incorrect installation.
4