Makita BHR200 Manual De Instrucciones página 9

NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the tool
body.
Dust cup (optional accessory)
003186
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006386
OPERATION
CAUTION:
Always insert the battery cartridge all the way until it
•
locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
When operating overhead, always make sure the
•
battery cartridge is locked securely so that it will not
be fallen out of the tool. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
Hammer drilling operation
003197
Set the change lever to the
Position the bit at the desired location for the hole, then
pull the switch trigger. Do not force the tool. Light
pressure gives best results. Keep the tool in position and
1. Dust cup
1
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
symbol.
prevent it from slipping away from the hole.
Do not apply more pressure when the hole becomes
clogged with chips or particles. Instead, run the tool at an
idle, then remove the bit partially from the hole. By
repeating this several times, the hole will be cleaned out
and normal drilling may be resumed.
CAUTION:
There is a tremendous and sudden twisting force
•
exerted on the tool/bit at the time of hole
break-through, when the hole becomes clogged
with chips and particles, or when striking reinforcing
rods embedded in the concrete. Always use the
side grip (auxiliary handle) and firmly hold the tool
by both side grip and switch handle during
operations. Failure to do so may result in the loss of
control of the tool and potentially severe injury.
Blow-out bulb (optional accessory)
002449
After drilling the hole, use the blow-out bulb to clean the
dust out of the hole.
Chipping/Scaling/Demolition
003203
Set the change lever to the
Hold the tool firmly with both hands. Turn the tool on and
apply slight pressure on the tool so that the tool will not
bounce around, uncontrolled. Pressing very hard on the
tool will not increase the efficiency.
9
1. Blow-out bulb
1
symbol.