Adjusting The Wall Arm; Setting The Height Limit On The Spring Arm D; Setting The Load Capacity On The Spring Arm - Ondal Acrobat 2000 Manual De Instrucciones

2

Adjusting the wall arm

2
Adjustin the wall arm
Please be sure to observe the safety information in section 1.
The wall arm
Figure 1

The spring arm
setting the height limit.
All settings are made with the enclosed size 5 Allen key.
Figure 2 2.1 Setting the height limit on the spring arm
When supplied, the height of the spring arm
tion A. The height limit can be raised by approx. 45 degrees.
1. Remove the plug
to prevent it being plugged in again / switched on again.
CAUTION – Damage to appliance:
Only raise the height limit so far that the spring arm
ance does not hit the ceiling.
2. Insert size 5 Allen key into the hole

To raise the height limit:
Turn the Allen key to the left (anticlockwise).

To lower the height limit:
Turn the Allen key to the right (clockwise).
3. Check height limit and repeat the procedure if necessary.
2.2

Setting the load capacity on the spring arm

Figure 3
If the spring arm
rises, the load capacity is set too high.
1. Remove the plug
to prevent it being plugged in again / switched on again.
2. Lift spring arm
3. Insert size 5 Allen key into the hole

To increase the load capacity:
Turn the Allen key to the left (anticlockwise).

To lower the load capacity:
Turn the Allen key to the right (clockwise).
4. Check load capacity and repeat the procedure if necessary.
/ consists of the extension arm
has a hole for setting the load capacity and a hole
/ switch off the wall power supply and take precautions
drops, the load capacity is set too low. If the spring arm
/ switch off the wall power supply and take precautions
approx. 10°. If necessary, raise height limit.
18
and the spring arm
is limited to the horizontal posi-
or the appli-
on the spring arm :
on the spring arm :
GB
B
:
D
for
D
D