Operation - Bartscher BS1240L Instrucción De Servicio

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
Before use position the device and leave it for at least 2 hours before connecting
to the power supply.
•
After a power outage or after removing the plug from its socket do not connect
the device to a power source for at least 5 minutes.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.

5.2 Operation

•
Before use, familiarize yourself with the device and its equipment based on this
instruction manual.
•
Clean the device thoroughly before use, following the instruction in
section 6. „Cleaning".
•
Close the door of the mini cold room.
•
Connect the device to a single grounded outlet.
•
Turn the device on using the ON/OFF switch integrated with the digital
temperature controller (keep pressed for ca. 5 seconds).
•
The digital display will show the temperature value, and the LED cooling
indicator LED
•
Place the prepared food in the mini cold room only when the appropriate cooling
capacity is reached.
and the LED temperature indicator will come on.
- 33 -