TRAPP JK-500 Manual De Instrucciones página 48

Wear proper clothes. Wear neither loose clothes

nor jewelry.
Take precautions against accidental running.

Make sure the switch is set to "off" before
plugging the equipment in. Failure to do so may
cause a serious accident.
Remove all objects before turning on the

equipment. A tool or any other object stuck in the
movable parts of the equipment may result in an
injury.
4- Use and care
Do not overuse the equipment. Use it in the right

way and for the purposes described in this manual
for better performance and safety while working.
Do not use the equipment if the switch does not

turn on/off. The equipment can not be controlled if
the on/off switch is damaged. A defective switch
shall be immediately repaired.
Switch off the circuit breaker, remove the fuses or

unplug the
substituting the cutting blades and accessories.
These safety preventive measures reduce the risk of
accidental operation of the equipment.
Do not allow people that are not familiarized with

the equipment to use it. The equipment may
become dangerous in the hands of people not
familiar with its operation.
Preserve your equipment. Frequently check if the

movable parts are fixed, if any component is
damaged or check for any other condition that may
affect its optimum operation. Shall any problem
arise, fix it before using the equipment. Many
accidents are caused by lack of proper maintenance.
Maintain the cutting blades sharp and clean.

48
equipment before servicing,
The cutting disc will remain in motion after the

machinery has been turned off. Therefore, pay
attention to this when doing any type of
maintenance.
Use the equipment and accessories according to

the instructions in this manual. Take in consideration
the working conditions and the service to be done.
Using the equipment for operations not covered in
this manual may result in dangerous situations.
Do not insert any material other than that

recommended into the JK multipurpose. If you need
to chop or shred another material that is not
recommended, you can contact the factory.
Note:
According to the Brazilian standard
NBR 5410, it is compulsory to install a device
to protect against residual differential current
(DR device) in the electrical installation of your
residence. The function of the "DR" is to protect
the user against serious electrical shock risk
(consult an electrician).
5- Service
Call qualified professionals to service the

equipment. Use original parts only. Always
call TRAPP Authorized Service Technicians.
TRAPP is not responsible for occasional
accidents caused by the use of spare parts that
are not original.
www.trapp.com.br