Bell EZFit Manual De Instrucciones página 7

Attach the speedometer sensor on the right fork of the front wheel using the cable tie.
Clamp the magnet on a spoke on the right side of the front wheel (Figure 2). Adjust the
position of the magnet so that when the wheel spins, the magnet will pass in front of the
lower section of the sensor (Figure 3). Clearance between magnet and sensor should not
be greater than 1/6" (4mm) (Figure 4). Once it is well positioned, tighten the magnet on
the spoke.
Note: Overtightening the screws can strip the threads or crack the assembly, so use caution.
Figure 2
MagNET aND SENSOR INSTallaTION
Figure 3
Sensor
Figure 4
Top view
Magnet
Magnet
Sensor
4mm
(1/6")
7