Helpful Tips - PiC indolor CSI 610 Manual De Instrucciones

Helpful tips

Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after eating a large meal.
• To obtain more accurate readings, wait at least one hour before measuring your blood pressure.
• Do not smoke or consume alcohol before measuring your blood pressure.
• Do not measure your blood pressure if you are physically tired.
• It is important to relax during measurement. Try to rest for 15 minutes before measuring
your blood pressure.
• Do not measure your blood pressure if you are tense or under stress.
• Measure your blood pressure at normal body temperature. If you are feeling hot or cold, wait
a while before taking a measurement.
• If the monitor is stored at very low temperature (near freezing), put it in a warm place for at
least an hour before use.
• Leave at least 5 minutes between measurements
Troubleshooting
If any faults should occur during use, please check the following points:
Symptom
Nothing appears on the dis-
play when the
ON/OFF/START button is
pressed
The EE symbol appears on
the display or the blood
pressure value is excessively
high or low
Note: If the unit still does not work, take it to an authorised Artsana service centre. Under no
circumstances should you disassemble and attempt to repair the unit yourself.
Warnings:
1. The appliance contains high-precision components. Therefore avoid extreme temperatures,
humidity and direct sunlight. Avoid dropping or vigorously shaking the main unit and pro-
tect it from dust.
2. Clean the monitor body and armband carefully with a soft and slightly damp cloth. Do not
press. Do not wash the armband or use chemical cleaners on it. Never use thinner, alcohol
or petrol as cleaning fluids.
3. Leaky batteries can damage the unit. Remove the batteries if the unit is not used for long
periods.
4. For safety reasons do not let children use the appliance.
5. If the unit is stored at temperatures near freezing point, allow it to acclimatise at room tem-
perature before use.
6. The CSI 610 is not field serviceable. Do not attempt to open the appliance using tools or
try to adjust anything inside it. If you have any problems, please contact an authorised
Artsana service centre.
Check point
Have the batteries run down?
Are the batteries inserted
correctly?
Is the armband correctly
applied in the proper posi-
tion?
Did you talk or move during
measurement?
Did you move your wrist
whilst wearing the armband?
17
Check point
Replace them with 4 new
alkaline batteries.
Reinsert the batteries in the
correct position.
Reapply the armband in the
correct position
Take the measurement again
without moving.