TFA 60.2525 Instrucciones De Uso página 9

TFA_No. 60.2525_Anleitung_09_16
Radio-controlled alarm clock
4. For your safety
• This product is exclusively intended for the field of application described above. It
should only be used as described within these instructions.
• Unauthorized repairs, modifications or changes to the product are prohibited.
Caution!
Risk of injury:
• Keep this instrument and the battery out of the reach of children.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged.
Risk of explosion!
• Batteries contain harmful acids. Low batteries should be changed as soon as
possible to prevent damage caused by leaking.
• Wear chemical-resistant protective gloves and glasses when handling leaking
batteries.
Important information on product safety!
• Do not place your product near extreme temperatures, vibrations or shocks.
• Protect it from moisture.
5. Elements
A: Display:
A1: Time, seconds and symbols
A2: Date, weekday, temperature
16
14.09.2016 16:02 Uhr
Radio-controlled alarm clock
B: Buttons:
B1: SNOOZE/LIGHT button
B3: ALARM button
B5: DOWN button
C: Housing:
C 1: Support with battery compartment
6. Getting started
• Remove the protective film from the display.
• Open the battery compartment and insert a new battery 1,5 V AA, ensure that
• Close the battery compartment again.
• The device will alert you with a beep and all LCD segments will be displayed for a
• The clock will now scan the DCF frequency signal and the DCF symbol
• The DCF receptions always take place at 1:00. 2:00 and 3:00 o'clock in the mor-
• If there is no reception possible, manual initialization can be helpful.
• Press and hold the WAVE button for 3 seconds.
• The DCF symbol will be flashing.
• To deactivate the reception, press and hold WAVE button for three seconds. The
Seite 9
the battery polarity is correct.
short moment.
flashing on the LCD. When the time code is received successfully after 3-8 mi-
nutes, the radio-controlled time, the date and the DCF symbol are displayed
steadily in the LCD.
ning. If the reception is not successfully received at 3:00 clock, it shall be held
further attempts until 5:00 clock.
DCF symbol disappears.
B2: SET button
B4: UP button
B6: WAVE button
will be
17