Trouble Shooting - BORETTI Michelangelo Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trouble shooting

Problem
Low heat or low flame when valve
turned to high.
Excessive flare-ups or un-even
heat.
Burners burn with yellow flame,
accompanied by smell of gas.
Burner will not light with igniter but
will light with match.
Humming Regulator.
72
Possible causes
For propane – improper lighting procedure.
Improper pre-heating.
Flame tamers installed incorrectly.
Improper pre-heating.
Excessive food waste on sear plates and
in drip pan.
Possible spider web or other debris.
Dead battery in igniter.
Loose electrode wire.
Improper gap at electrode tip.
Normal occurrence on hot days.
Solution
Ensure lighting procedure is followed
carefully. All gas grill valves must
be in the off position when the tank
valve is turned on. Turn tank on for
all pressure to equalize. See lighting
instructions.
Pre-heat grill with all main burners
on high for 10-15 minutes.
Ensure flame tamers are located on
pins in front and rear of firebox and
inline with burners.
Pre-heat grill with all main burners
on high for 10-15 minutes.
Clean flame tamers and drip pan
regularly. Do not line pan with
aluminum foil.
Thoroughly clean burner by remov-
ing. See maintenance instructions.
Change battery by turning igniter
cover clockwise to remove. Install
one AA battery. Install the battery in
the correct direction.
Check electrode wire is firmly
pushed onto the terminal on the
back of the igniter.
Ensure the collector box is tight and
the gap between the electrode end
and the collector box is between
1/8" and 3/16". The gap can be
adjusted by carefully bending the
spark electrode tip with a pair of
needle nose pliers.
This is not a defect. It is caused by
internal vibrations in the regulator
and does not effect the performance
or safety of the gas grill.

Publicidad

Tabla de contenido
loading

Tabla de contenido