Using The Coffee Maker - Dometic WAECO PerfectCoffee MC 08 Instrucciones De Uso

_MC08.book Seite 18 Dienstag, 27. September 2011 11:22 11

Using the coffee maker

Mounting on a surface
➤ Mount the base plate with four round-head bolts, washers and M 3 nuts
on a suitable surface (fig. 5 A, page 3). The diameter of the screw heads
may not exceed 6.5 mm.
➤ Place the coffee maker onto the base plate and screw the coffee maker
down by tightening the knurled screw on the base plate (fig. 5 B,
page 3).
Connecting the coffee maker
➤ Check that the voltage specification on the type plate is the same as that
of the power supply.
➤ Connect the DC plug to a DC socket.
NOTE
I
You can also connect the coffee maker directly to the battery. Ob-
serve the following in the process:
– The connection must be fitted with its own fuse of at least 20 A.
– The connection cable may not exceed a length of 5 m (for 12 V)
or 11 m (for 24 V).
– The cross section must be at least 4 mm².
7 Using the coffee maker
WARNING!
!
Only use the appliance when the vehicle is stationary, not during
journeys.
NOTICE!
A
If any liquid leaks out, clear it up immediately. Damage to the elec-
tronics may be caused by moisture entering the appliance.
Before initial use
➤ To clean the coffee maker, allow one to two lots of clear, cold water to boil
and flow through without the filter or coffee.
Do not fill the water tank above the maximum fill line.
➤ Pour the water away.
➤ Rinse the water tank, filter holder and pot with hot water.
18
PerfectCoffee MC-08
EN