Brother P-touch 9500PC Manual De Instrucciones página 252

Ocultar thumbs Ver también para P-touch 9500PC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

■ Connecting to a USB port
Follow the following procedures to connect
the PT-9500PC to the USB port of a personal
computer running Windows
2000 Pro/XP using the "Basic setup" (→ P.26)
or to the USB port of a Macintosh.
Note
The USB interface cable is connected to a
personal computer running Windows
while the software is being installed and
is connected to a Macintosh after the
software has been installed. Do not
connect the PT-9500PC to a personal
computer until instructed to do so.
Note
When making a USB connection through
a hub, a proper connection may not be
possible due to the type of hub used. If
this occurs, connect the PT-9500PC to a
personal computer directly with the USB
interface cable.
The PT-9500PC cannot be connected to
the USB port of a personal computer
®
running Windows
case, the PT-9500PC must be connected
to the serial port.
Prepare the included USB interface
1
cable.
Connect to PT-9500PC
USB port.
®
98/98 SE/Me/
95/NT 4.0. In this
Connect to personal
computer USB port.
2
Insert the plug on the end of the USB
interface cable into the USB port on the
back of the PT-9500PC.
3
Insert the plug on the end of the USB
interface cable into the USB port on the
personal computer.
• The location of the USB port varies
according to the personal computer.
For details, refer to the instruction
manual for the personal computer.
Note
To use the PT-9500PC, the software must
be installed on the personal computer.
Proceed to "Installing the software" (→
P.23).
17

Publicidad

Tabla de contenido
loading

Tabla de contenido