Cleaning And Maintenance; Troubleshooting - Ghibli SP8 Instrucciones Para El Empleo

USER INSTRUCTIONS
1) After opening the package, examine the contents to make sure that it is intact and in case of missing or defective
parts, contact an authorized dealer before using the machine, in order to receive the original parts.
2) Before connecting the machine check if the current corresponds with the technical data on the label.
3) Assemble suction hose, wands and suitable tool.
DRY - VACUUM CLEANER USE
A) Make sure that the cloth dust bag is fitted into its place. Every care must be taken to avoid damaging the cloth dust bag.
B) The tank must be perfectly dry and clean.
WET - VACUUM CLEANER USE
A) Remove the cloth dust bag.
B) Empty the tank from dust.
ATTENTION!! The machine has a float stopping the suction when the tank is full. In this case switch off the machine
and empty the tank.
COMMENTS ON SAFETY. ATTENTION!
1) Do not vacuum up dusts or liquids which are explosive, inflammable, poisonous or in anyway represent a danger
to health.
2) Every care must be taken to avoid damaging the main cable, in case of replacement, the same quality of cable must
be used. The replacement must be made by qualified personnel.
3) Never pick-up liquids with a dry vacuum cleaner.
4) Don't wash the machine by water sprays and never immerse the machine in water.
5) The packaging components (plastic bags, staples , etc..) can be potentially dangerous and should be kept out of
the reach of children.
6) In case of bad functioning or damage, disconnect the machine, contact an authorized dealer or service center,
request to have only original parts used.
7) This appliance must only be used for the purposes for which it has been constructed. The producer is not
responsible for eventual damages caused by improper used.

CLEANING AND MAINTENANCE

ATTENTION!! Before servicing, always disconnect the machine from the electrical supply.
1) Clean the tank, don't let any dust or dirt remain in it for a long time.
2) Clean the cloth dust bag accurately.
3) The cloth dust bag can be washed with a detergent in lukewarm water and must be completely dry again before re-use.
4) The machine can be cleaned with a damp cloth.
5) The motor is built for maintenance-free running. Only the carbon brushes and the collector should be checked
regularly and eventually be replaced by a service engineer.
PROBLEM
The machine does not start.
The machine suddenly stops.
Reduced suction power.
Suction power suddenly drops.

TROUBLESHOOTING

PROBABLE CAUSE
No current.
Because of overheating, the thermal
protection turned the machine off
(not available on all the machines).
Filter, nozzle, hose or tube clogged.
Tank full.
PROBABLE SOLUTION
Check main fuse, power cord, plug
and outlet.
After the machine has cooled down,
you can start it up again.
Check and clean.
Stop the machine and empty the
tank.