Technical Data; Wire Inlet, Fig; Feeding In The Wire - Binzel Rolliner NG Manual De Instrucciones

Rolliner NG
EN Mounting instructions

1 Technical Data

Outer diameter
Weight/meter
Minimum bending radius to insert the wire
Min. bending radius
Allowed torsion
Max. inside diameter
Tab. 1 Technical Data

2 Wire inlet, Fig. 1

3 Wire outlet, Fig. 3, 4, 5

4 Feeding in the wire

5 Rolliner NG Leading the
1 Insert the Rolliner NGinto the connection part and fix it with the screws.
1 Rolliner NG must be cut using a cutter, Fig. 3, inserted into the connection
part and fixed with screws.
NOTE
• Observe the minimum bending radius of 150 mm for feeding in.
• Insert the wire manually without exerting a lot of pressure.
1 Make sure that the wire end on a length of approx. 50 mm is straight and
insert it in the prescribed transport direction into the
NOTE
• Lay the Rolliner NG in the largest possible radius and protect it against
damages.
• Avoid the formation of ondulations caused by a too low number of
suspension points.
20 mm
150 grams
150 mm
120 mm
Weight/meter
2 mm (wire Ø1.6 mm)
1 Technical Data
Rolliner NG.
EN - 3