Trilux Belviso S EDS Serie Instrucciones De Montaje página 16

Button
long long
darker
Adjusting the brightness control target level
1. Modify the brightness and adjust it to the desired level by
pressing the button for a long period.
The brightness is modified. After the button is released, the
light intensity of the luminaire remains constant.
2. Shortly press the button twice within 30 seconds after
adjusting the target level.
Double flashing of luminaire confirms the correct saving.
The set brightness is saved as a new nominal value 5 seconds
after the flashing.
It is recommended to save the nominal value for brightness
control in conditions of low daylight.
Movement detector
With all detections of movement, the green LED on the sensor
lights up briefly. This enables checking whether people are in
the detection range of the movement detector or not.
Automatically switching the luminaire on/off
If the movement detector detects no movement during the
time set at the potentiometer, the light control device reduces
brightness to the minimum value and then switches the lumi-
naire off. The next detected movement switches the luminaire
on again if artificial light is required.
30
double
30 secs.
<
lighter
Button
short
off
30 secs.
Switching off via push button
Switching on via movement detection
If the luminaire was switched off with the push button, then
automatic switching on using the movement detector is only
possible after an interval time of 30 seconds without move-
ment. This means that only if movement is not detected for at
least 30 seconds, the next movement switches on the lumi-
naire if artificial light is required.
Tasto
short
long long
più buio
Deactivating automatic switch-on
Automatic switch-on of the luminaire via the motion detector
can be temporarily deactivated (e.g. with extended absence).
For this the luminaire must be switched on. Brightness must
not be manually modified 30 secs. before activation of the
vacation switching.
Briefly press the push button twice.
The luminaire switches off. Motion detection is deactivated
until the next switching on via the push button. The green LED
at the sensor permanently lights up.
Note:
If the brightness has been manually modified within 30 secs.
before pressing the button twice, the current brightness is
saved as the new nominal value.
double
off
>
> 30 sec
più luminoso
31