Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
19. Spark plug.
20. Pressure regulating valve.
21. Detergent suction connector.
22. Detergent tank.
INSTALLATION AND ASSEMBLY
Your pressure washer requires some assembly
and is ready for use after it has been properly
serviced with the recommended oil and fuel.
Tool need open-end wrench 10 mm, 14 mm, 17
mm.
UNPACKING
When unpacking check to make sure that all
parts are included. If any parts are missing or
broken, please call our distributor.
ASSEMBLY INSTRUCTIONS
1. Wheel Assembly.
NOTE: Make sure that there is enough air in
wheel before assembly.
Lift the frame (A) with one hand and attach
E N G L I S H •
one of the wheels (B) by pressing the wheel's
pin and inserting the wheel shaft into the main
frame (A). Align the pin with the hole on the
frame (A) until it snaps in. Repeat it for the op-
posite side.
2. Gun Holster Assembly. Attach the two gun
holster (E), one at the top and one at the bot-
tom. Secure them with bolts, washers, nuts (I).
Repeat this procedure for the upper one.
3. Body Assembly. Insert knob (H) to frame (A)
and secure clockwise. Repeat this procedure
for the second knob (H) on the opposite side.
U se r's m a n ua l
19
Publicidad
Tabla de contenido
