Workzone 44217 Manual Del Usuario página 10

12V Cordless Drill
3. REVERSIBLE [SEE C]
The forward/reverse rotation control located above the On/Off switch
control the direction of rotation. For drilling and screw driving use forward
rotation marked
" "(lever is moved to the left).Only use reverse rotation marked " "（lever is
moved to the right）to remove screws or release a jammed drill bit. When
the selector is in the center position, the switch is locked.
4. CHUCK ADJUSTMENT [SEE D]
To open the chuck jaws rotate the front section of the chuck. Insert the
drill bit between the chuck jaws and rotates the front section in the oppo-
site direction. Ensure the drill bits is in the center of the chuck jaws.
Finally, rmly rotates the front chuck section in the opposite directions.
Your drill bit is now clamped in the chuck. [SEE D]
5. TORQUE ADJUSTMENT[SEE D]
(Screw driving force of your drill driver)
The torque is adjusted by rotating the
torque adjustment ring. The torque is
greater when the torque adjustment
ring is set on a higher setting. The
torque is less when the torque adjust-
ment ring is set on a lower setting.
MAKE THE SETTING AS FOLLOWS
1-12 for driving small screws
6-12 for driving medium screws
12-18 for driving larger screws
for heavy drilling
6. SPEED CHANGE [SEE E]
• Always set the speed change lever
fully to the correct position. If you
operate the tool with the speed change lever positioned halfway between
the "1" side and "2" side, the tool may be damaged.
• Do not use the speed change lever while the tool is running. The tool
may be damaged.To change the speed, rst switch off the tool and then
slide the speed change lever to the "2" side for high speed or "1" side
for low speed. Be sure that the speed change lever is set to the correct
position before operation. Use the right speed for your job.
AFTER SALES SUPPORT
1800 505 8311
USA
Charging & Operation
D
E
acs@americancustomerservice.com
USA
Speed
change
Lever
10