Charging & Operation - Workzone 44217 Manual Del Usuario

12V Cordless Drill
When battery charge runs out after continuously use or
exposure to direct sunlight or heat, allow time for the battery
WARNING
to cool down before recharging to achieve the full charge
REMOVE OR INSTALL THE BATTERY PACK [SEE B]
Locate buttons on side of the battery pack. Depress the battery button to
release and slide it out from the tool. After recharge, insert back into the
tool. A simple push and slight pressure will be suf cient. [SEE B]
B
OPERATING INSTRUCTIONS
1. ON/OFF SWITCH [SEE C]
Depress to start and release to stop your drill. The on/off switch is tted
with a brake function which stops your chuck immediately when you
quickly release the switch. It is also a variable speed switch that delivers
higher speed and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
Do not operate for long periods at low speed because excess
heat will be produced internally
WARNING
Move the lever to the left or right
C
9
acs@americancustomerservice.com
2. SWITCH LOCK[SEE C]
The On/Off switch trigger can be
locked in OFF position. This helps to
reduce the possibility of accidental
starting when not in use. To lock the
switch, place the forward and reverse
rotation selector in the center position
by pushing it on either side of the drill.
Charging & Operation
AFTER SALES SUPPORT
1800 505 8311
USA
USA