Sawing With Special Base Runners; Sawing With The Angle Table; Sawing With The Base Adapter - Festool CARVEX PS 420 EBQ Manual De Instrucciones Original

11.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool jigsaw.

11.2 Sawing with special base runners

The special base runners protect high-quality
surfaces against scratches and scores.
► Press in the base runner at position [7-1].
► At the same time, push the base runner for­
wards.
► Mount another base runner and push it to
the rear until it engages.

11.3 Sawing with the angle table

The WT-PS 400 angle table is used for
cutting pipes or interior and exterior an­
gles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
Installing the angle table
► Remove the saw table [1-12] (see section
8.4 ).
► Position the angle table against the saw
base support.
► Close the lever [1-10].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
► Turn the adjusting wheel [8-1] to select the
required angle.
You can select the angles -45°, 0° and +45° on
the scale [8-2].
Sawing cutting depths
Risk of injury
► Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 0° cuts, we recommend setting the an­
gle table to a small negative angle to guar­
antee smooth operation.
7
7-1

11.4 Sawing with the base adapter

The ADT-PS 400 base adapter is used for at­
taching your jigsaw to the Festool guide rail and
the KS-PS 400 core maker.
(20 mm) and only use cross-set saw blades
(FSG).
WARNING
8-2
With guide rail and core maker: Observe
the max. material thickness of 6/8"
English
8-1
8
15