Installation Instructions; Using The Setup Wizard - Kyocera KR1 Guía De Instalación Rápida

Installation Instructions

Connect the Kyocera KR1 Wireless Router to Your Network
Ensure that power to your Kyocera KR1 Mobile Router is not connected before performing the
Note:
installation steps below.
32-bit PCMCIA (EVDO) Card or 1xEV-DO Mobile Phone Connection
To preserve the life of your phone's battery, it is recommended that you use your phone's charging
Note:
cradle when connected to the Kyocera KR1 Mobile Router.
Attach the antenna.
1.
a. Remove the antenna from its plastic wrapper.
b. Screw the antenna in a clockwise direction to the back panel of the unit .
c. Once secured, position the antenna upward at its connecting joint. This will ensure optimal reception
(see "Figure 1: Connections– Kyocera KR1 Mobile Router (Back View)" on page
Connect a compatible 32-bit PCMCIA (EVDO) card with service, or 1xEV-DO mobile phone with service,
2.
to your Kyocera KR1 Mobile Router in one of the following ways:
• Insert your wireless 32-bit PCMCIA (EVDO) card into the WAN (EVDO) 32-bit PCMCIA Card Slot, or
• Connect your wireless 1xEV-DO mobile phone to the "Phone In" jack, with your USB phone cable.
The Kyocera KR1 Mobile Router is designed to work with EVDO-capable handsets that can be used
Note:
as a modem (support tethered data). Please refer to your service provider for detailed feature
information. Support is also available at http://www.kyocera-wireless.com/support.
Insert the Ethernet patch cable into LAN Port 1 on the back panel of the Kyocera KR1 Mobile Router, and
3.
an available Ethernet port on the network adapter in the computer you will use to configure the unit.
The Kyocera KR1 Mobile Router LAN Ports are "Auto-MDI/MDIX." This provides either patch or
Note:
crossover Ethernet cable LAN Port access.
Connect the power adapter to the receptor on the back panel of your Kyocera KR1 Mobile Router.
4.
Then plug the other end of the power adapter into a wall outlet or power strip.
• The Power LED will turn ON to indicate power has been applied.
• Other LEDs will flash ON and OFF as the Kyocera KR1 Mobile Router performs initialization and Internet
connection processes. This will take a few minutes.
• When complete, the following LEDs will illuminate green: Power, Status, WAN, WLAN, and LAN Port 1
(or your specific LAN Port connection).
If you have connected a 1xEV-DO mobile phone to your Kyocera KR1 Mobile Router, the Phone LED
Note:
will also illuminate green.

Using the Setup Wizard

Once properly configured, your Kyocera KR1 Mobile Router will obtain and assign IP address
Note:
information automatically.
Perform the following steps to access the
Kyocera KR1 Mobile Router
Open your Web browser and type
1.
Run Wizard
.
http://192.168.0.1
web-management interface of the
in the URL address box. Press
3
2).
.
Enter