2.8
Adjusting seat comfort
Use instructions below to adjust the seat comfort for the patient :
2.9
Taking curbs by using ramps
WARNING:
Risk of tipping over – Never go up or down ramps without the aid of a
helper.
If you are considering the installation of ramps to overcome obstacles, kindly note the
following:
The chair is intended first and foremost to be used inside on level and solid surfaces. Never
go up or down ramps that are rough or have bumpy edges. Limit yourself to ascents or
descents with a maximum angle of 6%.
2.10 Transport in the car
DANGER:
Risk of injury – The shell chair is not suited for use as a seat in a
motor vehicle.
WARNING:
Risk of injury – See that the chair is attached properly in the car or
the truck.
Never use your shell chair as a seat in an automobile or other vehicle. The shell chair shall
be marked with following symbol.
To transport the shell chair in the car use following steps:
1.
Remove accessories.
2.
Store accessories safely.
3.
Place the chair in the luggage place.
4.
If the chair and the passenger compartment is NOT separated, attach the frame of
the chair securely to the vehicle. You can use the available safety belts in the vehicle.
3
Installation and adjustment
The instructions in this chapter are for the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
WARNING:
Variation of allowed adjustments can still change the stability of your
product (tilt back or sideways).
1. Open the zipper c on the side of the shell chair.
2. Take the big pump (air in) or small pump (air out)
out of the pocket on the side of the shell chair.
3. Pump the upholstery to adjust the seat comfort.
If you pump the air in the upholstery, be careful
you do not pump too much air in the upholstery.
Elios
2012-07