JIMTEN T-604 CC Manual De Instrucciones Y Mantenimiento página 28

T-604 CC WASTE DISPOSER
7.3. CASET DISSASSEMBLY AND REMOVAL.
Before attempting any operation, please verify the electrical power supply is off, or the
electrical cable has been disconnected from its base.
If the plate cover has been purchased:
- Remove the operating plate, in case it is a surface moun-
ted one, push it sideways & out to release (A). If it is a flat
operating plate, push both buttons and grab the glass
pulling it out of the magnet fixation (A). Unscrew stainless
steel frame, this will release the top glass cover.
- The top glass cover rests onto an inferior rail and it is kept
in its place by magnets on the top (B). Pull towards you
and up to take out the cover from its casing.
If the other register system has been installed:
- Remove the devised register, to access to the lower
compartment below the concealed cistern tank.
In every case:
- To remove the casset set (motor, pressure switch, blades,
capacitor) unscrew the 7 fixation screws from the main
body (C).
- Release the casset screws in the left side of the unit.
Screws will keep in place when loose.
Important!. Before removing screws
from the Caset pay attention to the water
level in the lavatory, it should be low.
Otherwise, you must decrease its level. There
is risk of pouring water in the concealed insta-
llation if this is not done before loosening
screws of the Caset.
- Remove the protection / ventilation protection.
- Remove the cable holder to the Caset, press sideways
and free the stop end, disconnect the connections
(faston) of the electrical cable to the engine & pressure
switch. Prepare an access area to rest the cable (conce-
aled part) until its re-connection.
- Manually remove all the Caset set by pulling up all the
motor set (D).
Safety notice:
- Pay attention to the Caset, which after a usage period
might be hot, attention to the sanitary macerator blade
which might be sharp.
- Substitute the Caset set using the spare and re-assem-
ble following the steps in reverse (check electrical
connections in page 29), screw and place the Caset
cover.
All the process can be done in less than 15 minutes.
28 - INSTRUCTIONS AND MAINTENANCE GUIDE