Adjusting The Air Flow Direction; Care And Cleaning; Operation Without The Remote Control Unit; Air Filter - Technibel Climatisation SCDV106C5VA Instrucciones De Uso

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL
The horizontal air flow can be adjusted by moving the vertical
blades to the left or right, as indicated in the following figure.
VERTICAL
Hold the end of the flap and move it up and down to adjust the
vertical air flow.
EG
CAUTION
Set vertical blades to the front position during COOLING/DRY
operation if humidity is high.
If the vertical blades are set to the left-most or right-most
position, condensation will form around the air outlet and
drip off.
Vertical Vane
Horizontal Vane
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles, follow
the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the button to select
the desired mode (COOL or HEAT).
NOTE
The set temperature and fan speed are automatically set at
the last selection before stopping.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the button until the
OPERATION lamp is turned off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
OPERATION
BUTTON

CARE AND CLEANING

CAUTION
For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
OUTDOOR UNIT
(CASING AND CONDENSING COIL)
Some metal edges and the condenser fins
are sharp and may cause injury if handled
improperly; special care should be taken
when you clean these parts.
Periodically check the outdoor unit to see
if the air outlet or air intake are clogged
up with dirt or soot.
The condenser and other components of
the outdoor unit must be cleaned
periodically.
Consult your DEALER or AFTER SALES
SERVICE.
INDOOR UNIT
Do not pour water on the unit to
clean it. This will damage the internal
components and cause an electric
shock hazard.
Never use solvents, or chemical
agents when cleaning the indoor
unit. Do not wipe the plastic casing
using very hot water.
Casing and Grille
Clean the casing and grille of the
indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft
cloth. If these parts are stained, use a
clean cloth moistened with a mild liquid
detergent. When cleaning the grille,
be careful not to force the blades out
of place.

AIR FILTER

The air filter behind the air intake grille should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
Hold the air filter by the tab at the top of the intake grille. And then
pull upwards.
8
SOLVENT
PETROL