Receiving The Sb750 Tm - Invacare ScanBed 750 Manual Del Usuario

4. Receiving the SB750
To avoid condensation, the bed should not be used until it has reached a temperature of 10-50° C.
Check whether the bed shows any signs of damage. If the bed is damaged, see terms of delivery.
If the bed has been delivered in parts, it must be assembled.
Cf. chapter 6 "Disassembly/Assembly of the SB750
Check, that the connection between mattress support
and base frame is properly locked (cf. the picture).
Check that all plugs of the motors and hand control are
correctly connected to the control unit according to the
printed symbols.
The bed must have the brakes engaged during nursing of a patient in the bed.
Disconnect the plug from the mains before moving the bed. The cable must be kept clear off the
floor and the castors during transport.
Connect the SB750 TM to the mains.
For ergonomic working position: Run the bed to approx. ½ height level.
Cf. chapter 2 "Operation of the SB750
Mount the accessories: Bed ends, side rails, lifting pole and bumper wheel.
Cf. chapter 5 "Fitting the accessories".
TM
Locked pin/
TM
".
snap lock
Unlocked pin/
snap lock
TM
".
11