Stihl FSE 60 Manual De Instrucciones página 12

English
checked to determine that it will operate
properly and perform its intended
function. Check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
condition that my affect its operation. A
guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center unless
indicated elsewhere in this manual.
WARNING
During cutting, check the tightness and
the condition of the cutting tool at regular
intervals. If the behavior of the tool
changes, stop the engine immediately,
and check the nut securing the tool for
tightness and the cutting tool for cracks
and damage. Replace damaged cutting
tools immediately. Such tools may
shatter at high speed and cause serious
or fatal injury.
WARNING
Keep hands and feet
away from cutting tool.
Do not grasp it when
picking up or holding the
trimmer. Never touch a
rotating cutting tool with
your hand or any part of
your body. It continues to
rotate for a short period
after the throttle trigger is
released (flywheel effect).
10
MAINTENANCE, REPAIR AND
STORING
Servicing of Double-Insulated Appliance
This electric trimmer is double-insulated.
In such an appliance, two systems of
insulation are provided instead of
grounding. No grounding means are
provided, nor should means for
grounding be added to the appliance.
Servicing a double-insulated appliance
requires extreme care and knowledge of
the system, and should be done only by
qualified service personnel.
WARNING
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Maintain your trimmer with care. Follow
the maintenance, lubrication and repair
instructions in the appropriate section of
your instruction manual. Never attempt
unauthorized repairs or open
powerhead.
WARNING
Always disconnect the plug from the
power supply and make sure that the
cutting tool is stopped before doing any
maintenance or repair work or cleaning
the electric trimmer. Do not attempt any
maintenance or repair work not
described in your instruction manual.
Have such work performed at your
STIHL service shop only.
Only authorized personnel may replace
the power supply cord. A damaged
power supply cord must be replaced by
an identical STIHL replacement part.
Check cooling air inlets about every ten
hours of operation and clean if
necessary. Do not use any strong
detergents on the plastic housing or
handle. They can be attacked by certain
house-hold cleaners containing
aromatic oils such as pine or lemon, or
by solvents such as kerosene.
WARNING
Do not spray water on the trimmer,
moisture can cause an electric shock
hazard. Wipe the unit with a cloth.
WARNING
Never repair damaged cutting
attachments by welding, straightening or
modifying the shape. This may cause
parts of the cutting tool to come off and
result in serious or fatal injuries.
WARNING
Check condition of cutting tool at regular
short intervals. If behavior of tool
changes, check it immediately for
tightness or any signs of cracks in
particular. Replace damaged or dull
cutting tools immediately, even if they
have only superficial cracks. If the tool
loosens after being properly tightened,
the retaining nut may be worn or
damaged and should be replaced. If the
tool continues to loosen, see your STIHL
dealer.
Tighten all nuts, bolts and screws before
and after each use.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of this manual.
FSE 60