Fuel Filling; Flame Ignition - TermaTech Biotronic Manual De Usuario

1. If the tank is empty (
and power cable 'b' (II) (
2. Place the fuel container stably on the floor and insert the pump hose 'c' (III). Press and hold the button
on the pump to start refuelling (IV).
Once the fuel container has been emptied, replace it with a full one and start the pump again (see point 2).
The pump will stop when the tank is full (sound +
3. Disconnect the power cable 'b'. To disconnect the pump, hold the end of the hose 'a' and firmly press the button
in the place marked with a sticker (V). Close the fuel inlet.
4. Shake the remaining fuel from the hose 'c' to the container and place the pump in the bag (VI).
The green diode indicates that the device is ready to ignite the flame.
Press and hold START for 3 seconds. Flame ignition will take 2-10 minutes (
present during the ignition. The diode READY off (
reached the working temperature.

FUEL FILLING

) or you want to fill the fuel, open the fuel inlet (I), firmly connect the pump hose 'a' (click!)
ATTENTION!
). Do not refuel when the flame is ignited!
I
c
III
b
a
V

FLAME IGNITION

II
IV
).
VI
) indicates that
the flame has been ignited and the device
5
a
b
c
). The smell of ethanol vapours can be