Publicidad
Idiomas disponibles
Idiomas disponibles
Emptying the
machine
Exchanging the
filter cartridge
Malfunctions
Maintenance
ENGLISH
After using the machine to collect up liquids, leave it standing open to dry. Take the
accessories apart and dry them as well. This is particularly important if the machine
is to be used for sweeping up dry matter later.
Due to the machin's high cleaning/air power as well as the optimum flow container
form (tangential–cyclone–principle; no obstruction, filter is protected from damage) it
is possible that after having switched the machine off some water will flow back from
the hose or the container. This can be sucked off when restarting work.
1.
Switch the machine off
2.
Pull the plug out of the socket.
3.
Open the snap-open grip and lift out the motor section.
4.
Empty the container and if necessary clean it.
5.
Fit the motor section and seal the snap–open grips.
1.
Open the snap–open grips and remove the
motor section.
2.
Fold the fastener to the side.
3.
Take hold of the filter cartridge by the grip
and pull it straight out of the filter guides.
4.
The filter cartridge can be cleaned with a
hand–brush – hold it over a container to
catch the dust. If it is very dirty or
damaged it should be replaced.
5.
Insert new or cleaned filter cartridge and
push in to its full extent.
6.
Fix the filter cartridge by folding back the
fastener.
7.
Fit the motor section and seal the snap–open grips.
The suction strength decreases.
Possible causes:
– The collection container is full
– The filter cartridge is clogged with fine dust
– The suction hose, the suction tubes, or the nozzles are clogged
with bulky material.
When dust is being swept up the dust is thrown out through the ventilation opening.
Possible causes:
- Filter cartridge not fitted properly
- Filter cartridge damaged.
If the malfunction is not caused by any of the above possibilities, please contact
your local AEG after–sales services.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320,
D–71361 Winnenden.
5
NT 1200, NT 1500 A
Publicidad
