Dishwasher Control Section; Dishwasher Feedback Section - Sears KENMORE ELITE ULTRACLEAN 665.1277 Serie Manual De Uso

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Top Rack Only

For added convenience, use for washing

a small load of dishes in the top rack to

help keep the kitchen continuously clean.

SmartDry™ or Heated Dry

(on some models)

Turns the heat element on, with fan assist

(on some models), at the end of the

wash cycle. Use rinse aid with or without

the SmartDry™ or Heated Dry option

for best drying results. Plastic items are

less likely to deform when loaded in the

top dish rack.

Selecting multiple options does not result in accumulative time and water from chart above.

†

Delay Hours (on some models)

Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak

hours when possible.

To delay the start:

1. Select a wash cycle and options.

2. Press the Delay button.

3. Press START/RESUME.

NOTE: Anytime the door is opened for more than 5 seconds (such as, to add a dish), the Start/Resume button must be pressed

again to resume the delay countdown.

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When Locked is lit, all buttons are

disabled. The dishwasher door can still be opened/closed while the controls are locked.

To turn on Control Lock:

Press and hold TOP RACK ONLY for 3 seconds. Locked will light. If you press any pad while your dishwasher is locked, the light

flashes 3 times.

NOTE: The dishwasher cannot start if the control is locked.

To turn off Control Lock

NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN, or by opening and closing

the door before you are able to turn off Control Lock.

Press and hold TOP RACK ONLY for 3 seconds The lights turn Off.

Indicators and Countdown Bar (on some models)

Selecting Cycles and Options

1. To repeat the same cycle/options used on previous cycle, press START/RESUME once to show which selections you used. To

change cycle, select desired cycle.

2. Select the desired options, then press START/RESUME to start the cycle. Not all options are available for every cycle. If an

invalid option is selected for a given cycle, the lights will flash.

Available with

Slightly faster wash for

any cycle

smaller loads

Cannot be used

with TurboZone

option

Available with

Turns the heat element on

any cycle except

at the end of the wash

Quick Rinse

cycle.