Dishwasher Control Section - Sears Kenmore ULTRA WASH 665.1241 Manual De Uso Y Cuidado

Options
High Temp
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Sani Rinse
This high temperature option sanitizes your dishes
and glassware in accordance with National
Sanitation Foundation (NSF)/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. The word Sanitized will light at the
end of the cycle when successfully completed. If
Sanitization is not achieved (most often due to
cycle interruption) the word Sanitized will flash.
Heated Dry
Turns the heat element on after the wash portion of
the cycle is over. Use rinse aid with or without the
Heated Dry option for best drying results. Plastic
items are less likely to deform when loaded in the
top dish rack.
*The maximum additional water used for any combination of options is 4.8 gal. (18.2 L).
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours
when possible. Delay displays how many hours Before the cycle will begin.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button. Each time you press the DELAY button it will display the next available delay time.
3. Press START/RESUME to begin the delay countdown.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to resume the delay
countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock indicator is lit, all buttons
are disabled. The dishwasher door can still be opened or closed while the controls are locked.
To turn on the Lock
Press and hold SANI RINSE for 3 seconds. The Lock indicator will light up. If you press any pad while your dishwasher is locked, the
light flashes 3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold SANI RINSE for 3 seconds. The light turns off
16
Can be selected
with
SmartWash
® H E
Raises the main wash
Pots & Pans temperature to 135°F
(57°C).
Normal Wash
Raises the main wash
H E
SmartWash
®
temperature to 135°F
Pots & Pans (57°C) and the final rinse
temperature to 156°F
Normal Wash
(69°C).
Available with
Turns the heat element on
any cycle
at the end of the wash
except
portion of the cycle.
Quick Rinse

Dishwasher Control Section

Added time
What it does
to cycle
0:05 to 0:13
0:05 to 1:01
0:08 to 0:43
Added
Water*
Gallons
(Liters)
0 - 3.9
(0 - 14.6)
0 - 3.9
(0 - 14.6)
0