Step2: Connect The Speakers - Onkyo TX-NR777 Manual De Instrucciones

> Before Start > Part Names

Step2: Connect the Speakers

a
a Speaker cable, b Subwoofer cable
14
> Install > Initial Setup
1/2˝
(12 mm)
b
> Playback
Standard Connections (Pages 8 to 11)
Up to two powered subwoofers can be connected. The
same signal is output from each of the SUBWOOFER PRE
OUT jacks.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P23).
0 If any of the connected speakers have an
impedance of 4 Ω or more to less than 6 Ω, after
completing Initial Setup, you need to make some
settings in the Setup menu. Press
remote controller, select "2. Speaker" -
"Configuration" and set "Speaker Impedance" to
"4ohms".
Make sure the exposed wires of the speakers
do not stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
on the