Cebora WIN TIG DC 220 M Manual De Instrucciones página 23

rameter, or turn knob B to select the desired parameter.
N.B The maximum adjustment value of the welding
current depends on the welding machine article.
4.2.1 SETTING OF FACTORY VALUES (DEF)
5 CHOICE OF WELDING PROCESS (SECTOR Q)
Confirm and
The processes available are as follows:
set the se-
lected pa-
r a m e t e r .
Then press
to confirm
the setting
and auto-
m a t i c a l l y
move on to
the next pa-
6 CHOICE OF TYPE OF ARC IGNITION (P SECTOR)
To restore
the factory
parameters,
select and
confirm the
"DEF" SEC-
TOR
C o n f i r m
choice
By adopting this method, it is possible to select, modify
and confirm all the types of ignition presented below.
Select and
confirm Q
sector.
high frequency/voltage discharge is generated which
lights the arc. Particularly suitable for precision spot
Select and
welding.
confirm the
welding pro-
c e s s . N . B .
the box for
the process
in use is
The duration of the parameters mentioned above may be
highlighted
adjusted from the main screen by selecting parameter
in green and
EVO ST. (see chapter 15).
boxed in red.
MMA Welding with covered electrodes (see
chapter 13))
TIG WELDING DC (see chapter 17)
TIG WELDING DC APC (Active Power Control,
See chapter 16)
High frequency (HF) ignition, the arc ignites by
high frequency/voltage discharge.
Contact ignition, touch the workpiece with the
electrode tip, press the welding torch trigger and
raise the electrode tip.
EVO LIFT Touch the workpiece with the electrode
tip, press the welding torch trigger and raise the
electrode tip; as soon as the electrode is raised, a
EVO START After the frequency/voltage dis-
charge, which lights the arc, the parameters are
set that favour joining of the edges of the material
to be welded during the first stage of welding.
Select and
confirm P
sector for
arc ignition.
Select and
confirm type
of ignition.
N.B. the box
for the pro-
cess in use
is highlight-
ed in green.
23