Removing The 5-Point Harness - Babyauto More Werdu RWF DS15 Manual De Instalación

Incorrect operation is understood as:
• The buckle clasps are notably slow to release
when the red button is pressed.
• The buckle clasps cannot be inserted (they fall
out when they are inserted into the buckle).
• The buckle clasps come together without making a
click.
• It becomes difficult to insert the clasps into the
buckle (resistance is felt).
• The buckle only opens when forced.
Solution
Clean the harness buckle so that it works properly.
3.3. Cleaning the harness buckle
1. Open the buckle (press the red button).
2. Hold the metal plate
position (fig.5).
3. Slide the metal plate
4. Remove the buckle
5. Steep the buckle
liquid detergent for at least one hour. Rinse and
dry it.

3.4. Removing the 5-point harness

1. Loosen the harness straps by pulling them at the
point where they cover the chest while pressing
the harness adjustment button
2. Locate the harness strap connector
38
(24)
from below in a vertical
(24)
along the slot.
(7)
.
(7) in hot water and neutral
(13) (fig.2).
(18)
unclip the harness straps, freeing them from the
connector, then remove them by pulling them
from the front of the seat (fig. 3 and 4).
3. Free the shoulder protectors
them from the connector that joins them (located
at the back of the seat) or, in the event they are
joined without a connector, by passing them directly
through the corresponding holes in the seat.
Harness
(13)
adjustment
button.
Harness
(17)
strap
connector
Shoulder
(18)
pads
connector
and
(3)
by unfastening
fig. 2
13
fig. 3
18
17