Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Incorrect operation is understood as:
• The buckle clasps are notably slow to release
when the red button is pressed.
• The buckle clasps cannot be inserted (they fall
out when they are inserted into the buckle).
• The buckle clasps come together without making a
click.
• It becomes difficult to insert the clasps into the
buckle (resistance is felt).
• The buckle only opens when forced.
solution
Clean the harness buckle so that it works properly.
3.3. cleaning the harness buckle
1. Open the buckle (press the red button).
(24)
2. Hold the metal plate
from below in a vertical
position (fig.5).
3. Slide the metal plate
(24)
along the slot.
(7)
4. Remove the buckle
.
5. Steep the buckle
(7)
in hot water and neutral
liquid detergent for at least one hour. Rinse and
dry it.
3.4. Removing the 5-point harness
1. Loosen the harness straps by pulling them at the
point where they cover the chest while pressing
the harness adjustment button
(13)
(fig.2).
2. Locate the harness strap connector
38
unclip the harness straps, freeing them from the
connector, then remove them by pulling them
from the front of the seat (fig. 3 and 4).
3. Free the shoulder protectors
them from the connector that joins them (located
at the back of the seat) or, in the event they are
joined without a connector, by passing them directly
through the corresponding holes in the seat.
Harness
(13)
fig. 2
adjustment
button.
(17)
Harness
fig. 3
strap
connector
Shoulder
(18)
pads
connector
(18)
and
18
(3)
by unfastening
17
4. Lift the fabric cover and keep the harness straps
folded in the corresponding seat hollow so that they
do not disturb the child. Replace the cover in its
place.
13
5. Turn the seat over and, from the back, free the
belt buckle
(24)
through the slot in the seat (fig. 5).
6. Remove the belt buckle and save it in the
storage bag.
7. Take off the harness straps by pulling them out of
the seat.
18
3.5. Removing the cover
A) Headrest.
1. Adjust the headrest to its highest position.
17
fig. 4
2. First remove the part of the cover that includes the
safety belt guide
the headrest cover.
B) To remove the 5-point harness, see point 3.4.
Remove the back and base covers.
(7)
by passing the retention plate
3.6. Putting the cover back on
Follow the same steps in reverse order.
IMPORTANT! Never use the safety seat following
the installation instructions described in point 5
without having a correctly installed buckle. Make
sure the metallic plate
24
(2)
followed by the remainder of
(24)
is properly secured.
39
Publicidad
Tabla de contenido
