Vacuuming Dry Material - Kärcher FI6565S Manual Del Usuario

3. Be sure the power cord is not plugged into an electrical outlet.
4. See Figure 2.2. Remove vacuum head (A) from tank (B) by pulling gently on the lower part of
the clamps (C) on the vacuum head.
5. Remove any accessories that may have been packed inside the tank.
6. Attach the vacuum head to the tank. Be sure that vacuum head is securely clamped to the
tank.
7. See Figure 3. Insert hose adapter (A) to the intake port (B) on the tank. To remove the hose
twist the hose adapter. Attach wand to the hose and the floor brush to the wand.
8. See Figure 4. Connect the hose adapter to the wand. Make sure that the wand with parking
hook is not connected directly to the hose with adapter.

9 - VACUUMING DRY MATERIAL:

! ATTENTION-For vacuuming of dry material it is highly recommended to use a HEPA filter.
9. Check to see that on/off switch, Figure 1 (1), is off (
10. See Figure 5. Attach insert with bristles (A) to floor brush. To change inserts, press the two
snaps on the ends of the floor brush.
Figure 2.2
Figure 3
Figure 4
0
).
7