Setting The Time; Setting The Alarm Clock - Hema 13.71.0280 Instrucciones De Uso

Rear:
Number Function
18. Battery compartment for CR2032 button cell battery (included).
19. Speaker
20. Input for adapter plug
21. FM aerial for better FM reception
Using the radio alarm clock
Connect the radio alarm clock by plugging the end of the adapter lead into the clock
(see 20) and the adapter plug into the mains socket. When using abroad, take care that
the voltage and frequency are the same as those stated on the adapter (230V/50Hz).

Setting the time

Set the time by pressing the PRESET (7) button. Make sure the radio is switched off when
doing so (1). The time display will now flash. Use TUN UP/HR (4) to set the hours, and TUN
DN/MIN (9) to set the minutes. When you have finished setting the time, press PRESET
again to confirm.

Setting the alarm clock

Two individual alarm times can be set.
Press VOL+/AL1 (5). Make sure the radio is switched off when doing so (1). The alarm time
will now flash. Use TUN UP/HR (4) to set the hours, and TUN DN/MIN (9) to set the minutes.
When you have finished setting the time, press VOL+/AL1 again to confirm.
You will now be automatically woken up by the alarm beeping. An indicator will light
up for AL1-B (14). If you would prefer to be woken by the radio, press VOL+/AL1 once
again. The set alarm time will flash. Press VOL+/AL1 again to select the radio alarm. After
a few seconds, the alarm time will automatically return to the time display. An indicator
will now be lit for AL1-R (15). The second alarm time can be set in the same way. To do so,
press VOL+/AL2 (10).
Switching the alarm on and off
If you have set an alarm time, one of the indicators at the top of the display will be lit.
If this is not the case, use VOL+/AL1 (5) or VOL-/AL2 (10) to switch on the alarm. The alarm is
switched off in the same manner. Once the alarm sounds, you can switch it off by pres-
sing ALARM OFF (12). The alarm will sound again at the same time the next day.
4