Cutter Adjustment - Opex OMATION Envelopener 410 Serie Manual Del Operador

4.3.3. Cutter Adjustment

The cutter depth has been adjusted from the factory and should not need to be
adjusted. If you find that mail is not being opened on cutter setting 1 and 2, the
cutter can be adjusted.
To adjust the cutter depth:
1. Set the Cut knob to the
should always cut standard mail deep enough to remove the contents but
not cut any of the contents. This position will be our reference. The other
positions will all be adjusted when this is changed.
2. Remove the nip assembly cover (see
on page 44).
Operation
OMATION® Series 410 Envelopener™ Operator Manual
"Standard Cut" position (Figure 4-19). This position
No Cut
Figure 4-19: Standard Cut position
OPEX Corporation
Deepest Cut
Deeper Cut
Standard Cut
"Cleaning the Series 410 Envelopener™"
49