Bostitch GF9033-E Instrucciones De Seguridad página 7

l Inspection at regular intervals is essential for
safety. Inspect the power tool at regular intervals so
that the tool can be operated safety and efficiently
at all times.
GB
l A void dangerous environments. Do not expose the
power tools or charger to rain and do not use the
power tool and charger in damp or wet conditions.
Keep the work area well lit. Never use power tools
and charger near flammable or explosive materials.
Do not use the tool and charger in the presence of
flammable liquids or gases.
l S tore the tool and charger in an idle state. When
not in use, the tool and charger should be stored in
a dry, high or locked-up place – out of the reach of
children and the infirm. Store the tool and charger
in a place where the temperature is less than 40°C.
l
l W hen the charger is not in use, or when being
maintained and inspected, disconnect the power
cord of the charger from the mains.
l T o avoid danger, always use only the specified
charger.
l T o avoid personal injury, only use the accessories
or attachments recommended in these handling
instructions or in the BOSTITCH catalogue.
l C heck and confirm that the supply cord and housing
are not damaged before using the charger. If the
supply cord of this charger or housing is damaged,
the charger must be returned to the BOSTITCH
authorised service center for the cord or housing
to be replaced. Only the authorised service center
should do these repairs. BOSTITCH will not be
responsible for any damages or injuries caused by
unauthorised persons attempting to repair the tool,
or mishandling of the tool.
l T o ensure the designed operational integrity of the
power tool and charger, do not remove installed
covers or screws.
l A lways use the charger at the voltage specified on
the nameplate.
l A lways charge the battery before use.
6
Do not abuse the cord. Never carry
the charger by the cord or yank it to
disconnect it from the mains. Keep
the cord away from heat, oil and
sharp edges.
l N ever use a battery other than that specified.
Do not connect a non-tool specific dry cell, or a
rechargeable battery other than that specified or a
car battery to the power tool.
l D o not use a transformer containing a booster.
l D o not charge the battery from an engine, electric
generator or DC power supply.
ADDITIONAL SAFETY EQUIPMENT
EYE PROTECTION which provides protection against
flying particles both from the FRONT and SIDE should
always be worn by the tool operator and others in the
work area when loading, operating or servicing this
tool. Eye protection is required to guard against flying
fasteners and debris, which could cause severe eye
injury. The employer and/or user must ensure that
proper eye protection is worn.
Eye protection in accordance with
89/686/EEC, and with equal or
greater grade than defined in EN166
should be used. However all aspects
of the operators work, environment
and other type/s of machinery being used should also be
considered when selecting any personal protection
equipment.
Note: Non-side shielded spectacles and face shields
alone do not provide adequate protection.
CAUTION: ADDITIONAL SAFETY PROTECTION may
be required in some environments.
For example, the working area may
include exposure to noise levels
that can lead to hearing damage.
The employer and user should
ensure that any necessary hearing protection is
provided and used by the operator and others in the
UN
work area. Some environments will require the use of
1950
head protection equipment. When required, the
employer and user must ensure that head protection is
used.
SAFETY PRECAUTIONS – GAS TOOLS
Be careful of ignition and
l
explosions.
This tool must not be used in a
combustible environment or in the
presence of flammable liquids or
gases. This tool produces hot exhaust
gases that may ignite flammable
materials and produces sparks. Since