Safety Information; Safety Precautions - OHAUS MB90 Guia Del Usuario

1. SAFETY INFORMATION

Definition of Signal Warnings and Symbols
WARNING
CAUTION
Attention
Note
Warning Symbols
General hazard
Hot surface
Toxic substance

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.
 Verify that the local AC power supply voltage is within the input voltage range printed on the AC adapter's ratings label.
 Only connect the AC adapter to a compatible grounded socket.
 Position the instrument such that the AC adapter can be easily disconnected from the socket.
 Position the power cord so that it does not pose a potential obstacle or tripping hazard.
 Operate the equipment only under ambient conditions specified in the user instructions.
Do not operate the equipment in hazardous or explosive environments.

 Disconnect the equipment from mains power before cleaning or servicing.
 Service should only be performed by authorized personnel.
Intended Use
Use the instrument exclusively for <weighing/moisture determination/etc.> as described in the operating instructions. Any
other type of use and operation beyond the limits of technical specifications without written consent from OHAUS, is
considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.
The Moisture Analyzer works with heat!

Never place flammable materials on, below or next to the Analyzer.

Use caution when removing a test sample. The sample, the sample chamber, the heating element and the
surrounding areas may be very hot and can cause burns.
Some samples require special care!

Should there be any uncertainty regarding the safety of a substance, perform a careful risk analysis. In such
cases, never leave the Analyzer unattended.

Fire or explosion: Substances which contain solvents or release flammable or explosive vapors when heated.
With such samples, work at drying temperatures low enough to prevent the formation of flames or an explosion.

Poisoning or burning: Substances which contain toxic or caustic components should only be dried in a fume
hood.

Corrosive: Substances which release corrosive vapors when heated should be tested in small amounts.

The user assumes responsibility for any damage caused by the use of these types of samples.
For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
For important information about the product.
For useful information about the product.
Electrical shock
Inflammable or explosive substance
Acid / Corrosion
EN-1